Activator 440 W | Adhesion promoter for primerless direct glazing applications

Activator 440 W is an activating agent specifically formulated for the pre-treatment of specific substrates used in the automotive sector to improve adhesion of U-Seal and SiMP-Seal windscreen adhesives. Its short flash off and wide range of application temperatures (from -15°C to 35°C) make the product suitable to be used under different environmental conditions.

Float glass and ceramic coated (frit) glass
Metals such as steel, stainless steel, aluminum, copper, electrogalvanized steel, etc.
Painted surfaces and coatings (epoxy and polyester painted sheet steel)
Original PU or MS adhesives cut surface for replacement

Tag:

LIÊN HỆ BÁO GIÁ

AREAS OF APPLICATION

Used to clean and promote adhesion on many different non-porous substrates, especially glass and ceramic- coated glass, metals, ceramics, painted surfaces. It is advisable to read NPT guidelines for the application cycle on car glass. Activator 440 W can be used to improve adhesion on the following non-porous substrates:

Float glass and ceramic coated (frit) glass
Metals such as steel, stainless steel, aluminum, copper, electrogalvanized steel, etc.
Painted surfaces and coatings (epoxy and polyester painted sheet steel).
Original PU or MS adhesives cut surface for replacement.

Technical Data

Appearance	Liquid
Color	Transparent
Chemical nature	Adhesion promoters in solvent dispersion
Density [g/cm3] (NPT method 06) (23°C and 50% RH)	ca. 0,7
Flash off [min] (23°C and 50% RH)	≥ 3*
VOC content [% w/w] (NPT method 78)	ca. 97
Application temperature [°C]	By cloth or abrasive sponge
Temperature Resistance [°C]	From -15 to +35

*Surface activation time Maximum 2h

Datasheet: Activator-440-W_TDS2021_eng_ver-5.0

User instructions

Ensure thorough cleaning of the substrate. Impregnate a lint free cloth or a mildly abrasive sponge with Activator 440 W to pass over the surface removing contaminants and leave it to dry for 3 minutes and no more than 2 hours. If sealant application has not been performed within 2 hours, it is possible to reactivate the surface by applying a second treatment of Activator 440 W, maximum one additional time. Ensure that activator is tack-free dry before proceeding to the adhesion process. Activator 440 W has a consumption of about 40 ml/m2. Close the bottle immediately after use. If Activator 440 W bottle is exposed opened for long time to the atmosphere, the liquid may become opaque with possible loss of performance, do not use opaque material. Assure to close hermetically the bottle after each use to avoid this effect. Consume within one week after opening. It is recommended to perform preliminary test before applying on substrates, including test for stress cracking. Do not use Activator 440 W for removing or tooling U-Seal or SiMP sealants.

Cleaning instructions

Clean the tools used with acetone or solvent. When the material has not yet hardened, it can be removed using paper or a cloth. Once hardened, the product can only be removed mechanically. Avoid skin contact by using latex, rubber or polyethylene gloves. If it comes in contact with the skin, remove immediately and wash with soap and water.

Storage

Activator 440 W can be stored for 12 months in its original packaging (unopened container) between 10°C and 25°C in a cool, dry place. The storage temperature should not exceed 25°C for extended periods of time. Keep away from wet areas, direct sunlight and heat sources.